Very Handy For Remote On-off of Things On Power Strip

Works great. I did the math and it saves about 3-4 dollars per item a year if it is just turned off at night. It will take a few years to pay for itself but worth it to me. The remote only works about 10-15 feet away.

Bought 5, then realized I needed 6, then realized I needed 7, then 8… then bought two as gifts. No problems with stuck rocker switch whatsoever. Remote control comes in a cover with double-sided tape on the back; or you can remove it. You can obviously use one switch with as many units as you’d like, or split them up on up to 8 channels if the neighbors aren’t also using these. I’ve only had the occasional issue with “oops one didn’t get the off/on signal”, in which case you just hold down the switch a bit longer. No dead units so far.

The surge protection for cable modems only comes with the 10-outlet model.

All the cords plug into this on a shelf under the built-in desk and we use the remote to turn things on and off. Has been working well for these several years.

So this fall when I got out our fancy low-voltage electric mattress pad, I realized we needed a second one of these. Being low voltage and queen size, the mattress pad has two brick size transformers, one for each side of the bed, separate from the controls. Even when the mattress pad is off, these things make a high-pitched buzzing noise. And we only have the mattress pad turned on to warm the bed up before we get in.

This product works great for this–the power strip sits on the floor under the bed, along with the transformers. The two transformers plug into outlets that are operated by the remote. Our alarm clock and bedside lamp plug into the two outlets on the power strip that are always “on” regardless of the remote. Now, we just have to click on the remote which is on the bedside table and turn on the mattress pad an hour before bedtime, then click off the remote to shut the mattress pad and the transformer noise off at bedtime.

*TIP* : if you are buying more than one of these, or buying your second one, you definitely need to change the sync switches to a new code so your remote operates the strip you intend to operate. I found that our remote in the home office does turn on and off the new power strip in the bedroom and vice versa, even though there is a wall and 15ft in between them. Once I changed the sync switches to a new code, problem solved. And it is easier to make this change initially, before you start plugging everything in.

Leave a Comment